[Elecraft] [K3] K3 in SS SSB

[Iain MacDonnell - N6ML]

On Tue, Nov 24, 2009 at 12:54 PM, Barry N1EU <barry.n1eu at gmail.com> wrote:
> On Tue, Nov 24, 2009 at 6:12 PM, Iain MacDonnell - N6ML <ar at dseven.org> wrote:
>>>>
>>>>
>>>>> Whether or not the K3 CAT API has been enhanced to make it
>>>>> easier to read the split state, Logger isn't supporting it yet.
>>
>> FWIW, I tried this N1MM Logger feature last night - I hadn't paid
>> attention to it before. It seems to work fine. I put the K3 into Split
>> mode with the buttons on the front - not via N1MM Logger, and it was
>> detected correctly. I didn't run a 48 hour contest with it, but a
>> quick test seemed to suggest it works well.
>
> I'm not sure which Logger feature you tried Iain, but 9.11.0 is the
> latest and "Reset RX freq to TX when QSO is logged (RUN & Split)" is
> NOT working if you manually put the K3 into split mode, call cq, tune
> off freq to pick up a caller and log the qso.  VfoA will stay off freq
> instead of being matched to vfoB as it should and as it works on other
> radios.

Don't know why it's not working for you - works fine for me. I'm using
K3 firmware revision 2.63 and N1MM Logger V9.11.0. I do have LP-Bridge
in the middle. Perhaps that's actually helping it to work?? I'll try
without at some point.

When you put your K3 in split mode, does the word "Split" appear to
the right of the "Buck" button in the N1MM Logger entry window?

    ~Iain /N6ML