[Elecraft] Fldigi Software and Hardware Settings for K3

[Julian, G4ILO]

John - N0EVH wrote:
> 
> I use VOX for transmit I believe, but am not in front of the setup right
> now.  Drop me an email if you can't get it going, I am gud on QRZ.
> 
No need to use VOX when you have a serial connection to your K3 for firnware
updating. Just download the K3 XML file from
http://www.w1hkj.com/xmlarchives.html and save it to the fldigi files
folder, go into the configuration and select the RigCat option, select this
file, set the com port and baud rate and select RigCat PTT. Click Initialize
and you should see the frequency and mode come up on the Fldigi display. If
so, you're good to go.

-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://n2.nabble.com/Fldigi-Software-and-Hardware-Settings-for-K3-tp3968534p3969199.html
Sent from the Elecraft mailing list archive at Nabble.com.