[Elecraft] Fldigi Software and Hardware Settings for K3

[John - N0EVH]

Frank, 

K3 runs the NBEMS software including the Flarq just fine.  Data mode A of
course.  There are startup instructions in the manual.  Run your sound card
audio in and out to the corresponding Line out and in on the K3.  Start with
Line level at about 30 and adjust for your best mileage.  I use VOX for
transmit I believe, but am not in front of the setup right now.  Drop me an
email if you can't get it going, I am gud on QRZ.

John N0EVH
-- 
View this message in context: http://n2.nabble.com/Fldigi-Software-and-Hardware-Settings-for-K3-tp3968534p3968759.html
Sent from the Elecraft mailing list archive at Nabble.com.