[Elecraft] K3...Getting the AM filter to work

[Eric Swartz - WA6HHQ, Elecraft]

Hi Antnee - The filter has to be enabled in K3 Utility for each mode. 
Make sure the AM boxes are checked. The offset should be 0 for the 6.0 
kHz filter.

If you are still unable to get it working over the weekend, try emailing 
k3support at elecraft.com and they should be able to help you.

If you want to talk to someone here, call Dale here at the Factory on 
Tuesday and he will get you up and running.

73, Eric  WA6HHQ


======
ANTNEE N3ANT wrote:
> AB3EN wrote:
>   
>> Have you set the filters up correctly? You can use the K3 Utility to do it
>> quickly and then use the XFIL button to check to see if the filters key in
>> properly.
>>
>> 73
>> Dan AB3EN
>>
>>
>> ANTNEE N3ANT wrote:
>>     
>>> Hello All,
>>> I installed a 6Hz. AM filter and am having trouble trying to get it to
>>> work ! ! ! I am wondering If I missed something in the upgrades and did
>>> Elecraft shut down the AM option in the radio for a little bit while they
>>> are working on upgrades ? I installed the filter in the first slot for
>>> the widest and then have the 2.8HZ and 2.1Hz. and so on... I read the
>>> manual many times and have all the other filters working fine ! ! ! maybe
>>> I missed something ? ? ?
>>>
>>> Antnee N3ANT
>>>       
>
> I am running K3 Utility ver. 1.2.3.18/firmware,MCU03.11/FPF 01.00/DSP 02.15
>
> I have it set up in the Utility...then check it in the radio
> I am starting to think I may have a bad filter ? ? ? 
> Installed it with the factory screw that came with it...1/4" shiny and on
> put a snug (not to firm) setting with the screw driver...maybe I'll call
> Inrad after the Holiday ! ! !
>