[Elecraft] SPL N/A with everybody on CW?

[Stewart Baker]

Yes, I too had the feeling that this used to work.

Stewart G3RXQ
On Fri, 19 Jun 2009 22:42:52 -0700, Brett Howard wrote:
> I should also state that I swear this was just working a minute 
ago and
> now I seem to always get SUB N/A unless both VFO's are on the 
same band.
>
> On Fri, 2009-06-19 at 22:20 -0700, Brett Howard wrote:
>> Right now I've got VFO A on 14.030.00 and VFO B on 7.027.00 and 
I'd like
>> to transmit on the VFO B freq.  Or I'm trying to setup N1MM so 
that when
>> I click on the VFO B log section that it switches on split so 
that I can
>> TX in the right band.  But I keep getting SPL N/A.  I even then 
tapped
>> A->B twice and then went back to those frequencies and still 
got SPL
>> N/A.  Seems like I'm unable to use the split and TX on VFO B if 
I'm on
>> independant bands?  And yes both are set to CW.
>>
>> Any ideas what I'm doing wrong?
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: 
http://www.qsl.net/donate.html