[Elecraft] k1 testing & alignment

[Don Wilhelm]

Ed,

Yes, the most likely place for your problem is the Pre-Mixer bandpass 
filter adjustment.
Since you have checked the oscillator outputs with your RF Probe, Use 
the RF Probe to monitor the output from the Pre-Mixer - adjust the 
Pre-Mixer for maximum RF Voltage at pin 6 of P1 on the filter board. 
This part can be done in receive.
If you have a CW receiver that can tune to the Pre-Mixer output 
frequency, use it to verify that you are really tuned to the correct 
frequency - the correct frequency will be the K1 dial frequency plus 
4915 kHz. You may have to bring an antenna wire connected to the 
receiver near P1 pin 6 to couple enough signal.

73,
Don W3FPR

E Neubauer wrote:
> I am at the Alignment and Test - Part I portion of constructing the K1.  All of the tests went GREAT up to the part about Band-Pass Filter Alignment (page 40).  With the antenna connected, I hear only white noise through the headphones.  Adjustment of the slug-tuned inductors does nothing. Connecting and disconnecting my antenna wire doesn't even make a crackle.  I ran the checks in the back of the manual with my RF probe under "Receiver and VFO Signal Tracing" (appendix E pages 5-6).  My input voltage with the battery pack was about 11.5 volts.  Here were the results for the numbered tests under that section:
> step 5: .02 V - OKstep 6: .222 V - OKstep 7: .025 V - a bit lowstep 8: 0 volts - fail.
> All steps after #8 that failed, as well.
> I suppose there is something wrong in the premix band-pass filter, but am not sure where to go from there to narrow the problem.  Again, any help is appreciated.
> Ed
> _________________________________________________________________
> Lauren found her dream laptop. Find the PC that’s right for you.
> http://www.microsoft.com/windows/choosepc/?ocid=ftp_val_wl_290
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.339 / Virus Database: 270.12.55/2160 - Release Date: 06/07/09 05:53:00
>
>