[Elecraft] SDR-IQ users?

[Gregory Fischer]

Thanks Bruce.  It didn't but that's because I don't have the K3  
connected directly to the SDR-IQ.

What I had to do after some trial and error was to go to the USB  
device properties and tell it to set up a virtual com port (in device  
manager).  Then I set LP-Bridge to the same port and restarted  
everything.

Now after a little tweaking of the IF freq and zero-beating with a sig  
generator it seems right on and tracks/controls the K3 fine.

73
Greg
AB7R


On Jul 31, 2009, at 3:46 PM, Bruce McLaughlin wrote:

> Start up SDR.  Then push the setup button and the cat submenu button  
> when it
> comes up.  You'll then see a choice of which com port you wish to  
> use along
> with the other parameters that are necessary to be set up.  That  
> should do
> the trick.
>
> Bruce-W8FU
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Gregory Fischer
> Sent: Friday, July 31, 2009 6:16 PM
> To: Elecraft Reflector
> Subject: [Elecraft] SDR-IQ users?
>
> Looking for some assistance in setting up SDR-IQ.  I ran the setup and
> connected the IQ and it is receiving sigs from the K3's IF.
>
> The problem is I cannot get it to communicate with the K3 to follow
> frequency changes from the radio....or when clicking on a signal to
> have it change the radios frequency.
>
> I would have thought that after the setup I would find something for
> the SDR-IQ in the device manager but I don't.....no com port setup for
> it or anything.  Did I miss a step somewhere?
>
> THanks
> Greg
> AB7R
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>