[Elecraft] SDR-IQ users?

[Bruce McLaughlin]

Start up SDR.  Then push the setup button and the cat submenu button when it
comes up.  You'll then see a choice of which com port you wish to use along
with the other parameters that are necessary to be set up.  That should do
the trick.

Bruce-W8FU

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Gregory Fischer
Sent: Friday, July 31, 2009 6:16 PM
To: Elecraft Reflector
Subject: [Elecraft] SDR-IQ users?

Looking for some assistance in setting up SDR-IQ.  I ran the setup and  
connected the IQ and it is receiving sigs from the K3's IF.

The problem is I cannot get it to communicate with the K3 to follow  
frequency changes from the radio....or when clicking on a signal to  
have it change the radios frequency.

I would have thought that after the setup I would find something for  
the SDR-IQ in the device manager but I don't.....no com port setup for  
it or anything.  Did I miss a step somewhere?

THanks
Greg
AB7R

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html