[Elecraft] [K3] dBV display

[Julian, G4ILO]

I don't use the dBV display very often, but since I last did many firmware
updates ago it seems to have developed a problem. Very often, the reading is
stuck on +99.9dBV. Sometimes, rotating the VFO B knob to select a different
reading, then back to dBV, gets it working. I'm in data mode with the AGC
off, though I'm not sure that is always the case when this happens. Can
anyone reproduce this? Perhaps it just needs a squirt of virtual WD40.

-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://n2.nabble.com/-K3--dBV-display-tp3326877p3326877.html
Sent from the [K3] mailing list archive at Nabble.com.