[Elecraft] N1MM and K3

[Fred Jensen]

Richard Meilstrup wrote:
> I need som advice to get my new K3 and N1MM work properly.  Only problem
> left is this:  *I cannot make N!MM key the K3*. My PC (XP) has serial ports
> and I use one of them. Will somebody out there tell me what to do?
> Rick, OZ5RM
> 

I don't have my K3 right now [in the Elecraft shop], but there is a menu 
item [CONFIG:RS232?] where you can select DTR and RTS for PTT and CW 
keying. Pick your choice, write it down, then go to N1MM and in the 
Configure menu item, choose the top one [Ports].  Select the COM port 
you're using, check CW, and put the DTR/RTS settings in the appropriate 
fields.  Works like a champ.

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2009 Cal QSO Party  3-4 Oct 2009
- www.cqp.org