[Elecraft] N1MM and K3

Iain MacDonnell - N6ML ar at dseven.org
Thu Jul 16 17:35:41 EDT 2009



Richard Meilstrup wrote:
> I need som advice to get my new K3 and N1MM work properly.  Only problem
> left is this:  *I cannot make N!MM key the K3*. My PC (XP) has serial ports
> and I use one of them. Will somebody out there tell me what to do?

Hi Rick,

Assuming already have the serial port for "rig control" and want to key
through the same port...

On the K3, set "CONFIG:PTT-KEY" to "rts-dtr"

In N1MM Configurer, Hardware tab, click "Set" for the appropriate serial
port, and set "DTR" to "CW" and "RTS" to "PTT".

Back at the Hardware tab, check the "CW" box for the port you just
configured.

That should do it...

     ~Iain / N6ML




More information about the Elecraft mailing list