[Elecraft] [K3] Power variations in K3 / 3.19

[Greg Williams]

I suggest that you make sure that you have run the "Calibrate 
Transmitter gain "  in the configuration section of the Elecraft K3 
Utility.  That fixed an issue I had that was similar to yours.

Greg VK3VT

Subject:
Re: [Elecraft] [K3] Power variations in K3 / 3.19
From:
ab2tc <ab2tc at arrl.net>
Date:
Thu, 9 Jul 2009 07:35:09 -0700 (PDT)

To:
elecraft at mailman.qth.net


I have this problem also, not only after power up, but after each band
change. My favorite workaround is to change mode to data FSK, switch to
dummy load, then press PTT  for a couple of seconds. Back to SSB and I have
full talk power immediately.