[Elecraft] K2 - RF Board part 2

[djmd]

Thanks Don, this did the trick!

Unfortunately I can't test it again on the dipole... mother nature decided
to dump an inch of ice on us which weighted down the antenna and took down
the mast holding up one end of it..... booo... I'm still a little bit
concerned about the strange noises I was hearing on and off throughout the
band when I was connected to the big antenna. But I think I am just going to
start part 3.





Don Wilhelm-4 wrote:
> 
> The first thing you should do when you get back to it Thursday is to put 
> the bottom cover on (using all 6 screws) if it is not already mounted, 
> and then run CAL PLL.  That should set your tuning straight. 
> 

-- 
View this message in context: http://n2.nabble.com/K2---RF-Board-part-2-tp2215492p2241655.html
Sent from the Elecraft mailing list archive at Nabble.com.