[Elecraft] K3 Suggestion

[Dick Dievendorff]

Does CONFIG:PWR SET to the "PER BAND" choice meet your needs?

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of 4CX250B
Sent: Monday, January 26, 2009 3:55 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Suggestion

This may have been covered before, but I'd really like the K3 to allow
band-specific power settings. Since there's no provision for amplifier ALC,
it would be helpful to set the power output on a band-by-band basis. In
other words, if an amplifier takes 40Watts drive on 40m but 60 Watts on ten
meters, one could adjust the power output on each band once and then have
the K3 remember the settings. Solid state amps, especially, often have
frequency-dependent gain.

73,

Jim W8ZR
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com