[Elecraft] K3 Suggestion

[Iain MacDonnell - N6ML]

4CX250B wrote:
> This may have been covered before, but I'd really like the K3 to allow band-specific power settings. Since there's no provision for amplifier ALC, it would be helpful to set the power output on a band-by-band basis. In other words, if an amplifier takes 40Watts drive on 40m but 60 Watts on ten meters, one could adjust the power output on each band once and then have the K3 remember the settings. Solid state amps, especially, often have frequency-dependent gain.

Hi Jim,

Set "CONFIG:PWR SET" to "PER-BAND".

HTH,

     ~Iain / N6ML