[Elecraft] K2 Control board

[Don Wilhelm]

Mike,

You have it correct.  An identifying mark is used for pin 1 - whether 
that is a dot or a bar is the component manufacturer's choice.  The 
important thing is that pin 1 is identified by some distinctive mark.

73,
Don W3FPR

Mike Weir wrote:
> Hi all,
> Just starting the build of the control board and on page 14 putting in 
> the resistor packs. I notice that my RP5 is a red resistor pack part 
> number 103C471T48. It does not have the Dot but a solid line do I 
> match the solid line with the number one on the board. Just wanted to 
> make sure before I solder it in place as this pack did not have a dot.
> Thanks
> Mike
>
> VE3WDM
>