[Elecraft] K2 Control board

[Dick Dievendorff]

I'd look at the schematic and see if I could figure out how it's supposed to
be wired internally and then verify with an ohmmeter that the presumed dot
is where you think it should be.

 

Dick, K6KR

 

 

 

From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mike Weir
Sent: Sunday, January 18, 2009 5:44 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K2 Control board

 

Hi all,
Just starting the build of the control board and on page 14 putting in the
resistor packs. I notice that my RP5 is a red resistor pack part number
103C471T48. It does not have the Dot but a solid line do I match the solid
line with the number one on the board. Just wanted to make sure before I
solder it in place as this pack did not have a dot. 
Thanks
Mike

VE3WDM

 

  _____  

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20090118/7d8bf5a9/attachment.html