[Elecraft] [K3] Front/Rear MIC Input Level

[Dr. Werner Furlan]

hi Merv, 

Merv Schweigert schrieb am 11 Jan 2009 um 11:51:

> I just checked mine #2306,  cannot get ALC above 7 bars either,  Heil
> proset, mic setting of 8 to 10 is plenty to get full power out.  But even
> if setting mic to 60 ALC is still 7 bars max.   But I notice that below the
> ALC bar scale ALC brackets go to 7 bars,  perhaps that means full scale?  I
> am using the rear panel jack also,  manual states 5 to 7 bars max.  As far
> as power output less, thats normal check the CONFIG:  TXG VCE menu and set
> the gain up a small amount,  will bring SSB up to CW power level. Use an
> external meter as the K3 bar may not respond fast enough to show peaks on
> SSB. Merv KH7C

I checked again and it is exactly the same here. I have a LP-100 peak meter 
and it shows 100 Watt out in SSB with MIC GAIN 20 COMP 20. 
With normal speech I have only 2-4 bars of ALC, with OOOOLA I get 5-6.

73! de Werner OE9FWV


-- 
 Viele Hunde gehen gern ins Wasser. Manche leben sogar immer dort, das
 sind die Seehunde.


Email powered by Pegasus Mail free at <http://www.pmail.com>
Homepage: <http://www.qsl.net/oe9fwv/>
Fone +43 5522 75013
Fax +43 5522 75013 15
Mobile +43 664 6340014
Elecraft K2 #5203 K3 #656