[Elecraft] K3 Beta firmware rev. 2.82

[Doug Alspaugh]

Hi Steve,

Seems to work correctly here even if I exceed the recommended 5  bars of 
ALC.



73 Doug N3QW


----- Original Message ----- 
From: <Steven.Zabarnick at notes.udayton.edu>
To: <elecraft at mailman.qth.net>
Sent: Wednesday, February 11, 2009 9:16 AM
Subject: Re: [Elecraft] K3 Beta firmware rev. 2.82


>
> I installed the new beta last and tested the new output power control. I
> don't see any improvement in PSK31 output power using DATA A mode. I still
> get nearly twice the output power than I have dialed in by the PWR knob. 
> In
> the previous firmware, the measure output power in CW modes agreed with 
> the
> PWR knob setting, but now the power output in CW is 20-30% higher than the
> setting.
>
> I will try to redo the transmitter gain calibration to see if this helps.
>
> Steve N9SZ
> K3 #1672
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html