[Elecraft] K3 Beta firmware rev. 2.82

[Steven.Zabarnick at notes.udayton.edu]

I installed the new beta last and tested the new output power control. I
don't see any improvement in PSK31 output power using DATA A mode. I still
get nearly twice the output power than I have dialed in by the PWR knob. In
the previous firmware, the measure output power in CW modes agreed with the
PWR knob setting, but now the power output in CW is 20-30% higher than the
setting.

I will try to redo the transmitter gain calibration to see if this helps.

Steve N9SZ
K3 #1672