[Elecraft] K3 utility program

[Dick Dievendorff]

The K3 Utility filter configuration dialog helps you to completely set  
up filter bandwidth, offset, gain, rx filter select by mode, and Tx  
filter select by mode. There is a screen shot in K3 Utility Help that  
shows this.

Dick, K6KR


Sent from my iPhone

On Dec 11, 2009, at 4:20 PM, Mike Weir <ve3wdm at hotmail.com> wrote:

>
> Good evening all
> I am about to set the K3 up using the K3 utility program. To  
> configure the filters of which I have the Stock  2.7 khz 5 pole  
> crystal filter, inrad 500 400 and 250 filters. Does the utility take  
> you through all the steps that are in the manual on page 46  
> (bandwidth, frequency offset and transmit crystal selection) or do I  
> have to go back and forth from the k3 utility to the manual for  
> complete filter setup?
> Mike
> VE3WDM
>
> _________________________________________________________________
> Windows Live: Make it easier for your friends to see what you’re up  
> to on Facebook.
> http://go.microsoft.com/?linkid=9691816
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html