[Elecraft] K3 utility program

[Iain MacDonnell - N6ML]

On Sat, Dec 12, 2009 at 2:20 AM, Mike Weir <ve3wdm at hotmail.com> wrote:
>
> Good evening all
> I am about to set the K3 up using the K3 utility program. To configure the filters of which I have the Stock  2.7 khz 5 pole crystal filter, inrad 500 400 and 250 filters. Does the utility take you through all the steps that are in the manual on page 46 (bandwidth, frequency offset and transmit crystal selection) or do I have to go back and forth from the k3 utility to the manual for complete filter setup?

Not really sure what you mean by "go back and forth...", but the K3
Utility presents a form where you specify all of the filter parameters
for the filters in either the main or sub receiver, then submit it to
the K3. It's quite straightforward.

    ~Iain / N6ML