[Elecraft] K3 VFO B Anomaly

[W2LE]

That makes sense, my second rcvr doesn't have a BPF3 - only the main 
rcvr has it.

Bob W Allen wrote:
> W2LE wrote:
> My K3 does the same thing tuning VFO A or B at 4800, probably you can't 
> have separate bandpass filters on the VFOs so the other frequency has to 
> change.
> Bob
> KB1FRW
>
>
>   
>> I see similar strange things when tuning VFO A around 4.800.  When VFO A 
>> is below 4.800 B is at 4799.96 - when A goes above 4.800 B goes to 5.285 
>> MHz.  This is on SN 1114 - 3.25
>>
>> Glad I don't normally listen there.
>>
>> Paul  W2LE
>>
>> Robert Beard wrote:
>>   
>>     
>>> Good Morning List,
>>>
>>> Just noticed, while tuning VFO A down through 4.800.0 MHz, I can hear a relay switching. 
>>> I believe this is band pass filter switching on the KBPF3 board.
>>>
>>> All well and good, except that VFO B jumps to 3.526.76 MHz at the switching point, regardless of any previous setting.
>>>
>>> When tuning VFO A back up through 4.8 MHz., the relay switches and VFO B jumps to 5.300.00 MHz.
>>>
>>> Anyone else seeing this curious behavior? (Or am I missing something....?)
>>>
>>> K3 is s/n 1500 with 3.14/2.16/2.16 installed.
>>>
>>> Best regards,
>>>
>>> Rob, N6VX
>>> ______________________________________________________________
>>>     
>>>       
>>   
>>     
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>