[Elecraft] K3 Hardware Updates

[Brett Howard]

Well just mucked around on the bands for a bit (about 40 minutes or so)
with the hardware mods in place and switched it back to SPI1 and I
wasn't able to get anything to behave strangely...

However in trying to recall the change from memory I did find that
pressing 8 while in VCO MD changes what appears to be a tolerance
settingg?  The possible choices were MFG and NOR.  I ended up leaving it
back at NOR...  Wonder how many of those little tricks are hidden
about...

~Brett

On Sun, 2009-08-23 at 19:14 -0700, Ron D'Eau Claire wrote:
> Hi Brett. After putting in the diodes and resistors the VFO in my K3 was
> unstable until I changed to SPI 2. 
> 
> Wayne thought this was normal. 
> 
> Ron AC7AC
> 
> -----Original Message-----
> Actually I believe that the signals will be plenty stable if you place
> the hardware mod but don't change the frequency.  However speeding
> things up (using the SPI2 setting) w/o proper termination is going to
> cause problems.  
> 
> ~Brett (KC7OTG)
> 
> 73
>