[Elecraft] K3 FW3.25 Auto-Notch Filter problem.

[Stewart]

Tried it again using my XG2 as a signal source, and it's working OK.

Gremlins at work !

73
Stewart G3RXQ
On Sat, 15 Aug 2009 11:03:23 +0100, Stewart wrote:
> As you say Brett ... Interesting.
> I will try it again, and look for any new Menu settings that may have crept in unnoticed.
> This was on SSB, a mode which I use almost 100% of the time.
>
> 73
> Stewart G3RXQ
> On Sat, 15 Aug 2009 02:24:57 -0700, Brett Howard wrote:
>> Interesting..  Mine seems to be working as it did before.  I just tied
>> it on a few AM stations near 40.  Got in the area in LSB got it setup
>> with the carrier in my window hit the button and poof gone.
>>
>> I then found another tone that seemed to be drifting back and forth a
>> little bit and hit the auto notch on that.  It seemed to notch it but
>> was following it a bit slowly so it was just off of it every so often
>> but it was updating and keeping things quieter.
>>
>> I also QSYed quickly when the notch was doing its thing and you hear the
>> tone come back for a short bit then you hear the filter slide over and
>> keep the carrier covered up.
>>
>> Are you sure you're in a mode that supports the auto notch?  Its not
>> supported in DATA or CW.
>>
>> ~Brett (KC7OTG)
>>
>>
>> On Sat, 2009-08-15 at 10:07 +0100, Stewart wrote:
>>> am finding the same here - AGH !
>>>
>>> The Manual notch is fine, however, although there is a slight
>>> notching action in Auto it is virtually useless.