[Elecraft] ERR TXG

[Eric Merlen]

Hi Bret,

Thanks for the suggestion.

I confirm I set the 2.7Khz  filter as the TX filter for all modes but AM
where the 6Khz filter is used.

I left FIL1 slot empty as I plan to add an FM filter at some point (and more
filters for CW/data) later, but according to the manual, that's fine to do
so.

One think worth mentioning: I had to apply significant pressure on the
three  transistors mounted on LPA board when I installed the lower bottom
panel because the transistors raised slightly above the bottom panel level.
I don't know if it is normal (ensure good thermal contact?) or if I used the
wrong screws somewhere.

Eric

On Sun, Aug 9, 2009 at 4:33 AM, Brett Howard <brett at livecomputers.com>wrote:

> Make sure you have set the 2.7K filter as the TX for all modes where it
> makes sense.  (all but AM in your case it would appear)
>
> ~Brett
>