[Elecraft] ERR TXG

[Brett Howard]

Make sure you have set the 2.7K filter as the TX for all modes where it
makes sense.  (all but AM in your case it would appear)

~Brett

On Sun, 2009-08-09 at 07:42 +0000, Eric Merlen wrote:
> Good morning folks,
> 
> I assembled a K3/10 + KBPF3 + AM filter (+ default 2.7Khz filter). After
> synth calibration, filter setup, ref oscillator calibration I performed TX
> gain calibration using Electraft K3 utility, but it fails immediately with *ERR
> TXG*.
> 
> Filter setup is
> Fil1: none
> Fil2: 6.0Khz (0hz), 0db
> Fil3: 2.7 (-0.85Khz), 0dB
> 
> Any idea of what the problem could be?
> Thanks
> 
> Eric ve2shf
> 
> 
> REF:
> Starting 5 watt calibration
> Calibrating at 1.900 MHz
> IsSamplingComplete: Unexpected response "DS@@@@@>>@€€;" to "DS;" State 153
> Calibration power settled at "  0.0 W ;"
> 5 watt calibration failed
> Elapsed time: 7 seconds
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html