[Elecraft] Line In not working ?

[Mario Lorenz]

Hello,

getting finally around to setting up my K3 for RTTY/PSK,
ie. hooking the line in/out to the computer, I noticed that
Line In doesnt work for me.

- Cables are OK (tested by plugging into MIC IN, the signal
is rather loud but there)
- MICSEL to LineIn, and line level have been tried up to 60
- Some time ago when I had my K3 open I had done all the mods re. audio
(mainly line out and the gnd mods) . I double-checked and all seems as
per spec...
- Using an ohmmeter to measure into line-in yields 630 ohm which looks
about right as per schematic, so I didnt short-circuit things...
- I updated firmware to 3.10

Could someone please confirm that Line In does work with fw rev 3.10 ?
Any further ideas ?

Mario

-- 
Mario Lorenz                            Internet:    <ml at vdazone.org>
                                        Ham Radio:   DL5MLO at DB0ERF.#THR.DEU.EU
The deorbiting of MIR was brought to you by radio FFH and MIRcrosoft, your
specialist for controlled crashes!  (local radio station, on the very day)