[Elecraft] K3 PSK31 with Digipan

[zibs]

But in Data A mode, one can expand the receive width out to 4 kHz using the
2.7 kHz filter. If you attempt to transmit below 200 or above 2800 Hz, power
output will drop to zero.

The user needs to be aware when clicking on the waterfall as one can receive
signals on frequencies in which they cannot transmit.

Steve N9SZ



Lyle Johnson wrote:
> 
>  > Just getting my new K3 working on PSK31 and noticed that it seems to be
>  > > important to limit the range of the transmit frequency...
> 
> I just swept my K3 in DATA A mode.using the LINE IN jack for sourcing
> the Tx audio.  It is flat from below 200 Hz to higher than 2800 Hz
> using a 2.,8 kHz IF filter.
> 
> Be sure you don't have TxEQ set to restrict the transmit bandwidth.
> TxEQ is active for *all* Tx audio paths in all modes.  For DATA A or
> DATA AFSK, it should be flat.
> 
> 73,
> 
> Lyle KK7P
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://n2.nabble.com/K3-PSK31-with-Digipan-tp1100818p1100983.html
Sent from the Elecraft mailing list archive at Nabble.com.