[Elecraft] K3 PSK31 with Digipan

[Tim Heasman]

Hi All,

I have noticed this problem as well, and also with the sdr 1000.  I just 
widen the tx passband on the sdr 1000, so perhaps we could use the 6 kHz 
filter for A mode data transmission.

73

Tim

gm4lmh

----- Original Message ----- 
From: "zibs" <zabarnick at udayton.edu>
To: <elecraft at mailman.qth.net>
Sent: Friday, September 19, 2008 2:12 PM
Subject: [Elecraft] K3 PSK31 with Digipan


>
> Just getting my new K3 working on PSK31 and noticed that it seems to be
> important to limit the range of the transmit frequency. Using Digipan and 
> K3
> Data A mode, if I select a transmit frequency on the waterfall that is too
> high or low, I will get very low (or zero) power output. It seems like one
> needs to keep this frequency centered in the transmit filter bandpass (I 
> use
> the 2.7 kHz filter for transmit) -- so should I always transmit near 1.3
> kHz? I never noticed needing to limit this range when using my IC-756 with
> Digipan.
>
> Steve N9SZ
> -- 
> View this message in context: 
> http://n2.nabble.com/K3-PSK31-with-Digipan-tp1100818p1100818.html
> Sent from the Elecraft mailing list archive at Nabble.com.
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com