[Elecraft] KRX3 Installation Step

[Vic K2VCO]

Roy Morris wrote:
> On page 34 of the Installation and Opeation manual it says to remove
> the W4 jumber soldered between two pads located between J64A and the
> KIO3 board.  My K3 RF board is Rev A.  W4 is hard wired between two
> pads located between J64A and the KBPF3 board mounted above the K3 RF
> board.  It looks as if I am going to have to temporarily remove the
> KBPF3 board to remove this jumper.  Am I missing something here?  Roy
> Morris  W4WFB

No, you might have to take it out. I used a dental pick to break the 
jumper on my K3 (serial no. 7).
-- 
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco