[Elecraft] KRX3 Installation Step

[Stewart Baker]

That's what I did.

73
Stewart G3RXQ
On Mon, 8 Sep 2008 08:00:42 -0400, Roy Morris wrote:
> On page 34 of the Installation and Opeation manual it says to 
remove the W4 jumber
> soldered between two pads located between J64A and the KIO3 
board.  My K3 RF board is
> Rev A.  W4 is hard wired between two pads located between J64A 
and the KBPF3 board
> mounted above the K3 RF board.  It looks as if I am going to 
have to temporarily remove
> the KBPF3 board to remove this jumper.  Am I missing something 
here?  Roy Morris  W4WFB
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com