[Elecraft] Another One Born

[Brett Howard]

You should read through your manuals and the errata.

Method 3 is not yet supported.  However contrary to the beliefs of some
you ARE getting added accuracy from your KTCXO3 it is a 1PPM reference
rather than 5PPM.  With firmware correction (to be added later) it
should be able to reach 0.5PPM but that level has yet to be realized.  

VFO IND is not yet implemented in the firmware.  To be implemented later

For your HP calibration what do you have your tun pwr set to?  Should be
normal.  If you have it set to 5 watts that may be part of your problem.

On Mon, 2008-09-01 at 20:14 -0400, Bob Leschyna wrote:
> Hi All,
> 
> I received my kit on Friday August 29 and spent this weekend putting it 
> together (K3/100, KAT3, KBPF3, KFL3A-6k, KFL3A-2.8K, KFL3B-FM, KRX3, 
> KTCX03-1 and KXV3. Yes, I had to hold off for one week as I could not 
> block the time to do it. All seemed to go well, everything checked out 
> along the way and it seems to work, except for a few setup/calibration 
> issues that I can not figure out.
> 
> 1) When I try to Calibrate the Reference Oscillator using Method 3, I 
> can get to the CONFIG:REF CAL, I see 49.380.000 but when I "Tap 1" 
> nothing happens?
> 
> 2) High Power (50 W) TX Fain Calibration, it only shows 5.0W as it did 
> with the (5 W) Calibration?
> 
> 3) When in VFO IND, it says NO, when I try to change it to YES, it won't 
> go, and it then shows "UNAVAIL"?
> 
> Any advice would be greatly appreciated.
> 
> Thanks
> 
> Bob
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com