[Elecraft] VFO A follows VFO B

[Barry N1EU]

Ron Lodewyck wrote:
> 
> After clicking on a packet spot which put the K3 in split mode with VFO 
> B up 1 Khz I now find that pressing Rev and tuning, simultaneously 
> changes BOTH VFOs.  If I release the Rev button and tune my VFO A then 
> VFO B simultaneously changes by the same amount.  Move A up 1.1 Khz, 
> then VFO B also moves up 1.1 Khz.  Never did this before and cannot find 
> a way to unlock this tracking behavior.  The only thing I find relevant 
> in the K3 User Manual is  Config: VFO B>A which displays "Function" but 
> I cannot change this to anything else by rotating the VFO A knob.
> 
> This behavior only exists on the 20M band - it goes away on all other 
> bands.  I have turned the radio off and back on and no change.  I know 
> it must be a QLF on my part but danged if I can figure it out.  Any 
> suggestions?
> 

Not sure, but you might have your VFOs  linked on the 20M band.  Go to 20M
and push the SUB button until you see "UNLINK".

73,
Barry N1EU

-- 
View this message in context: http://n2.nabble.com/VFO-A-follows-VFO-B-tp1399646p1399694.html
Sent from the Elecraft mailing list archive at Nabble.com.