[Elecraft] VFO A follows VFO B

[Ron Lodewyck]

After clicking on a packet spot which put the K3 in split mode with VFO 
B up 1 Khz I now find that pressing Rev and tuning, simultaneously 
changes BOTH VFOs.  If I release the Rev button and tune my VFO A then 
VFO B simultaneously changes by the same amount.  Move A up 1.1 Khz, 
then VFO B also moves up 1.1 Khz.  Never did this before and cannot find 
a way to unlock this tracking behavior.  The only thing I find relevant 
in the K3 User Manual is  Config: VFO B>A which displays "Function" but 
I cannot change this to anything else by rotating the VFO A knob.

This behavior only exists on the 20M band - it goes away on all other 
bands.  I have turned the radio off and back on and no change.  I know 
it must be a QLF on my part but danged if I can figure it out.  Any 
suggestions?

TIA & 73,
Ron N6EE