[Elecraft] memory problem

[Steef PA2A]

Hi,

I turned on the K3 today and all CW was gone. Pitch had become 000, where I always use 550. Filter width, LO and HI were giving strange results.

In LSB on 40 meters, if I tap memory M1-M4 the passband of the signals become smaller but LO/HI, BW and WIDTH do not change. Going to CW and back to LSB the receiver seems normal again. Because there is no KDVR3 installed, I usually got the message: NO DVR or N/A when tapping one of the 4 memories. Now unpredictable things happen.

NORM also sets the receiver back to normal. Does anyone have the same problem? Reloading the firmware 257 a few times does not correct the problem.

73 's Steef PA2A
K3 1184
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081028/fb304bdd/attachment.htm