[Elecraft] PR6 6-Meter Pre-amp Manual error.

[Robert Friess]

I thought that the correct pin was 11.

Bob

On Thu, Oct 23, 2008 at 10:17 AM, Ron D'Eau Claire <ron at cobi.biz> wrote:
> A-yup! The correct pin is 6. A corrected manual will be on the web site
> soon.
>
> The PR6 comes with a pre-assembled cable to connect it to the power and ACC
> output on the K3.
>
> The connection pin was shown for those who will want to remove the connector
> and add the control wire to an existing connector, such as the connector
> from an XV transverter.
>
> Ron (red faced again) AC7AC
>
> -----Original Message-----
>
> Head's up on the PR6 6-Meter Manual.  On page 3 of the manual it states that
> the white control wire from the PR6Pre-amp should go to "Pin 6" of the ACC
> connector.  However, the drawing actually shows that wire going to Pin 11,
> which is highlighted.
>
> I ordered one anyway!
>
> Terry, W0FM
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>