[Elecraft] PR6 6-Meter Pre-amp Manual error.

[Ron D'Eau Claire]

A-yup! The correct pin is 6. A corrected manual will be on the web site
soon. 

The PR6 comes with a pre-assembled cable to connect it to the power and ACC
output on the K3. 

The connection pin was shown for those who will want to remove the connector
and add the control wire to an existing connector, such as the connector
from an XV transverter.

Ron (red faced again) AC7AC

-----Original Message-----

Head's up on the PR6 6-Meter Manual.  On page 3 of the manual it states that
the white control wire from the PR6Pre-amp should go to "Pin 6" of the ACC
connector.  However, the drawing actually shows that wire going to Pin 11,
which is highlighted.  

I ordered one anyway!

Terry, W0FM