[Elecraft] [K3] VFO A tracks VFO b, Help

[Don Wilhelm]

Ted,

It has always worked like that.   If you previously had VFO A and VFO B 
showing different bands, I would think you had a display problem.
Currently even with the KRX3 installed, cross-band operation is not yet 
implemented in the current firmware, but is being addressed as a planned 
future firmware addition (only for those with the KRX3).

73,
Don W3FPR

wa6riv wrote:
> I updated my firmware and caused a problem. I have not purchased a sub 
> receiver and is not installed.
> When I'm in VFO A, and do a band change, VFO B follows the same band.
> I can swap A=>B or B=>A, move from A to B or B to A.
> But I can't have VFO A on 40 meters and VFO B on 20 meters.
> The Band switch transfers both VFO's to the same band at the same time.
>  
> What have I done?  Tnx Ted WA6RIV 
> ------------------------------------------------------------------------
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com 
> Version: 8.0.173 / Virus Database: 270.8.0/1722 - Release Date: 10/13/2008 7:50 AM
>
>