[Elecraft] K3: Error in KRX3 installation instructions?

[Ron D'Eau Claire]

The step should say black, not zinc. 

Additional 3/16" screws are supplied with your filters, one per filter. 

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Paul Ferguson
Sent: Friday, October 10, 2008 11:55 AM
To: Elecraft at mailman.qth.net
Cc: support at elecraft.com
Subject: [Elecraft] K3: Error in KRX3 installation instructions?


I am in the middle of installing my KRX3 and came to a point where I do not 
have enough of the correct screws remaining. I am using KRX3 Installation
and 
Operation manual Rev B (Aug 20, 2008) and Errata Rev B-2 (Sep 30, 2008). 

My inventory matched the manual as modified by the Errata. I might have used

the wrong screws somewhere, so I went back thru the steps keeping track of
what 
the steps say I should have used. 

I came to a problem on page 31, step 2. It calls for two 4-40 3/16" zinc pan

head screws. The inventory does not list any of the above screws. There are 
zinc pan head 4-40, 1/4" and black pan head 4-40 3/16" screws. I do not know
if 
I used zinc 1/4" or black 3/16" during this step. What should this step say?


Paul Ferguson
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com