[Elecraft] K3 with N1MM question

[Carl Clawson]

Randy, it sounds like you have N1MM set up to activate PTT via serial
command to the radio. Look in your COM port config page for a checkbox where
you can turn off "Radio PTT via command".

GL & 73,
Carl, WS7L
K3 #486

> -----Original Message-----
> I enjoyed last weekend operating SSCW with my new K3/10 and 
> N1MM.  Both were a joy to use!!  I have one curiosity 
> however.  I have the K3 setup for semi-QSK with a delay of 
> 0.03 which works fine for me at about 25 wpm.  However, the 
> keying through N1MM operates as though PTT is enabled at the 
> beginning of a transmission and disabled at the end.  In 
> other words, I hear no signals during the N1MM transmission.  
> I'm keying through the RS232 port on the K3 from a standard 
> serial port on my PC (same cable as used for the CAT from 
> N1MM).  I have PTT--KEY set to OFF-dtr, N1MM set for DTR-CW, 
> RTS-Always off.  Is there something I'm missing?
> 
> 73,
> Randy, KS4L
> K3 #2006
> K2 #337