[Elecraft] K3 with N1MM question

[Joe Subich, W4TV]

Make sure you have not checked "Radio PTT via command" in 
the N1MM set-up of the K3 COM port if you expect to be able 
to operate QSK or VOX (semi break-in). 

73, 

   ... Joe, W4TV 
 
 
 

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Randy Moore
> Sent: Friday, November 07, 2008 9:13 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] K3 with N1MM question
> 
> 
> I enjoyed last weekend operating SSCW with my new K3/10 and 
> N1MM.  Both 
> were a joy to use!!  I have one curiosity however.  I have 
> the K3 setup 
> for semi-QSK with a delay of 0.03 which works fine for me at about 25 
> wpm.  However, the keying through N1MM operates as though PTT 
> is enabled 
> at the beginning of a transmission and disabled at the end.  In other 
> words, I hear no signals during the N1MM transmission.  I'm keying 
> through the RS232 port on the K3 from a standard serial port on my PC 
> (same cable as used for the CAT from N1MM).  I have PTT--KEY set to 
> OFF-dtr, N1MM set for DTR-CW, RTS-Always off.  Is there something I'm 
> missing?
> 
> 73,
> Randy, KS4L
> K3 #2006
> K2 #337
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com