[Elecraft] K3 with N1MM question

[Ken K3IU]

Randy:
In N1MM, go to the configurator, hardware tab, and click on the Set 
button for your K3. Make sure that the "Radio PTT via command" is NOT 
checked.
73, Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~

Randy Moore wrote:
> I enjoyed last weekend operating SSCW with my new K3/10 and N1MM.  
> Both were a joy to use!!  I have one curiosity however.  I have the K3 
> setup for semi-QSK with a delay of 0.03 which works fine for me at 
> about 25 wpm.  However, the keying through N1MM operates as though PTT 
> is enabled at the beginning of a transmission and disabled at the 
> end.  In other words, I hear no signals during the N1MM transmission.  
> I'm keying through the RS232 port on the K3 from a standard serial 
> port on my PC (same cable as used for the CAT from N1MM).  I have 
> PTT--KEY set to OFF-dtr, N1MM set for DTR-CW, RTS-Always off.  Is 
> there something I'm missing?
>
> 73,
> Randy, KS4L
> K3 #2006
> K2 #337
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>