[Elecraft] K3 TX equalizer messes up PSK

[Alexandr Kobranov]

About DATA this is more problematic to make some internal sub-modes as 
a lot of external-driven modes use the same MODE without any 
OTHER_CONDITIONS useful for this mentioned system.

In my case, if there will be real chance to have EQ profiles stored, I 
will leave RXEQ1 ant TXEQ1 as FLAT and this combination will be used 
for data modes, maybe for WSJT there will be RXEQ9 and TXEQ9 ready but 
manually selected when want to go WSJT with specific not so "flat" 
soundcard.
The rest of pre-sets will be used for SSB (as using 2 mikes - front 
and rear so let´s say TXEQ2 for front and TXEQ3 for rear one) and 
surely there will be at least 1 RXEQ for SSB and 2 or three RXEQ 
settings for CW (as using several headphones/loudpeakers etc..)

Sorry if going so deep in my dreams :-)

73!
L. -dst-

Erik N Basilier napsal(a):
> These sound like good ideas, but please don't forget separate "eq modes" 
> for the
> data modes, unless flat eq is set automatically for all the data modes.
> The latter approach would be fine for me, and a lot simpler. Does anyone 
> have
> a need for other than flat settings for data? As to the approach with 
> "eq modes"
> I assume that would be implemented as a new menu within CONFIG?
> 
> 73,
> Erik K7TV
> 
> ----- Original Message ----- From: "Alexandr Kobranov" <kobranov at amoscz.cz>
> Cc: <elecraft at mailman.qth.net>
> Sent: Thursday, November 06, 2008 12:10 PM
> Subject: Re: [Elecraft] K3 TX equalizer messes up PSK
> 
> 
> You are right, Julian.
> 
> So what about to keep SSB FP MIc/SSB RP Mic/AM FP Mic/AM RP Mic/FM FP
> MIc/FM/RP Mic as "independent modes" keeping their own TX/RX EQ Settings?
> So yes, let´s have 10 EQ pre-sets and make table of possible "modes"
> to keep information about EQ pre-set. There is no need to limit "mode"
> only to CW/AM/FM/SSB - there are possible some more precious like Rear
> or Front panel Mic used etc...why not.
> Any other idea?
> 
> 73!
> L. -dst-
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>