[Elecraft] Re: K3 and DXBase

[Bill Parry]

Thanks to all that responded.

+The manual said specifically not check DTR and RTS, so I did not.  I tried
to check them and it made no difference.

+The radio, the comport (6) and DXBase are all set to 4800 baud.

I have not tried to use the 38,400 baud setting, but I have had more than
one person say that the 4800 does work. If I was more knowledgeable, I could
be a little more specific.  (Maybe I should call the Geek Squad :-)

Brendan, I believe that you sent the update for radio.ini but I didn't want
to add another variable to a situation that I am at a loss how to fix.

Bill

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Brendan Minish
Sent: Tuesday, November 04, 2008 2:21 PM
To: Tony Morgan
Cc: Elecraft at mailman.qth.net
Subject: Re: [Elecraft] Re: K3 and DXBase

You do not need those lines high, indeed I would not recommend it as
these lines can be enabled on the K3 as PTT/Keying lines. In this case
having these lines high will place the K3 in transmit  

I have a k3 update that you can add to the radios.ini file for explicit
K3 support in dXbase  but it is functionally the same as the k2 file for
now 


73
Brendan EI6IZ 


On Tue, 2008-11-04 at 11:53 -0800, Tony Morgan wrote:
> Should have added
> RTS high
> DTR high
> 
> 73,
> 
> Tony W7GO
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
-- 
Don't complain. Nobody will understand. Or care. And certainly don't try
to fix the situation yourself. It's dangerous. Leave it to a highly
untrained, unqualified, expendable professional.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com