[Elecraft] K3 - HAGCMDKT mod kit

[Eric Swartz - WA6HHQ, Elecraft]

Either is OK.

73, Eric  WA6HHQ


N2TK wrote:
> Eric,
> Tnx for  the info. I just measured R33 and R40 - 6.3 ohms. At this stage
> does it matter whether I leave the shorts in place or should I solder these
> two resistors back?
>
> N2TK, Tony 
>
> -----Original Message-----
> From: Eric Swartz - WA6HHQ, Elecraft [mailto:eric at elecraft.com] 
> Sent: Wednesday, May 28, 2008 1:18 PM
> To: N2TK
> Cc: 'Elecraft Reflector'
> Subject: Re: [Elecraft] K3 - HAGCMDKT mod kit
>
> Hi Tony,
>
> Nothing was required on your part. That is the factory version of the 
> change that already has very low value SMD resistors installed for R33 
> and R40.
>
> 73, Eric  WA6HHQ
>
>
> N2TK wrote:
>   
>> Went to install the HAGCMDKT kit on #311. Interesting but all was already
>> done except for shorting R33 and R40. Maybe there were interim fixes for
>> this mod?
>>
>> By the way, C222 had already been changed to .1 uF for the CW Keying Rise
>> Time Reduction. I needed to add the RXA board to the KXV3.
>>
>>
>> N2TK, Tony
>> #311
>>
>>   
>>