[Elecraft] K3 - HAGCMDKT mod kit

[N2TK]

Eric,
Tnx for  the info. I just measured R33 and R40 - 6.3 ohms. At this stage
does it matter whether I leave the shorts in place or should I solder these
two resistors back?

N2TK, Tony 

-----Original Message-----
From: Eric Swartz - WA6HHQ, Elecraft [mailto:eric at elecraft.com] 
Sent: Wednesday, May 28, 2008 1:18 PM
To: N2TK
Cc: 'Elecraft Reflector'
Subject: Re: [Elecraft] K3 - HAGCMDKT mod kit

Hi Tony,

Nothing was required on your part. That is the factory version of the 
change that already has very low value SMD resistors installed for R33 
and R40.

73, Eric  WA6HHQ


N2TK wrote:
> Went to install the HAGCMDKT kit on #311. Interesting but all was already
> done except for shorting R33 and R40. Maybe there were interim fixes for
> this mod?
>
> By the way, C222 had already been changed to .1 uF for the CW Keying Rise
> Time Reduction. I needed to add the RXA board to the KXV3.
>
>
> N2TK, Tony
> #311
>
>