[Elecraft] Fwd: K3: High-Power TX Gain Calibration - No Output

[Joe Word]

I fixed the problem. Removed KPA3 and found a gray wire out of T1, at
the C1 end,  was under the  mounting bracket (KPA3 to RF Shield). The
K3 now puts out full power and the High Power Gain Calibration is
complete for all bands.

Thanks Gary at Elecraft for the excellent help.

And thanks to all of you for your comments and suggestions.

What a nice receiver!!!


73,

Joe  N9VX


---------- Forwarded message ----------
From: Joe Word <joe.n9vx at gmail.com>
Date: May 13, 2008 11:28 AM
Subject: K3: High-Power TX Gain Calibration - No Output
To: elecraft at mailman.qth.net


I am having problems with the 50 watt TX Gain Calibration, it shows 0
watts and gives the error "ERR TXG". The Low-Power 5 watt test
worked fine and have low power output.

Anyone had and resolved this problem?

Running FW 1.88

Thanks,

Joe  N9VX

K3 #841