[Elecraft] Fwd: K3: High-Power TX Gain Calibration - No Output

[David Wilburn]

I would next open up the K3 update tool, and under the Configuration 
tab, select the click on the Edit Crystal Filters... button.  In what 
ever mode you were getting the TX error on, ensure that one of buttons 
on the bottom 4 (including FM if applicable) lines is selected for 
that mode.  As an example, in my case, the 2.70 filter is selected for 
Tx CW, Tx SSB, and Tx AM.


Dave Wilburn
K4DGW
K2/100 - S/N 5982
K3/100 - S/N 766

"For those who fought for it, freedom has a flavor the protected will 
never know."


Joe Word wrote:
> Dave, PA is set to nor and have turned off/on multiple times.
> Just checked the Circuit Breaker, it's making contact.
> 
> Joe
> 
> Dave wrote..
> Have you initialized the PA in the menu and turned the rig off and on
> a couple of times?
> 
> 
> Dave Wilburn
> 
> 
> -----------------------------------------------------------------------------------------
> 
> ---------- Forwarded message ----------
> From: Joe Word <joe.n9vx at gmail.com>
> Date: May 13, 2008 11:28 AM
> Subject: K3: High-Power TX Gain Calibration - No Output
> To: elecraft at mailman.qth.net
> 
> 
> I am having problems with the 50 watt TX Gain Calibration, it shows 0
> watts and gives the error "ERR TXG". The Low-Power 5 watt test
> worked fine and have low power output.
> 
> Anyone had and resolved this problem?
> 
> Running FW 1.88
> 
> Thanks,
> 
> Joe  N9VX
> 
> K3 #841
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>