[Elecraft] K3: Shift behaviour

[Alexandr Kobranov]

Ok Ken,
thanks,

will go through later - maybe there are some other params to check.
And reload FW :-)

Thanks for now,
73!
L. -dst-
K3/10 #727


Ken K3IU napsal(a):
> I can not duplicate this on #202 with the latest firmware. It stops at 
> FC=0.10 even if I keep rotating the knob anti-clockwise.
> 73,
> Ken K3IU
> 
> Alexandr Kobranov wrote:
>> Hello friends,
>> want to know if i missed something:
>>
>> - when on CW mode turning SHIFT to low-end it is going to 0.00 and 
>> then jump to 2.7 and radio is "off" (no signal like I/F switched off).
>> It is for BANDWIDTH 2.8kHz and the same for 0.05kHz so bandwidth 
>> independent.
>> On SSB mode SHIFT is going to 0.4 and stop here, no jump to 2.7.
>> Latest F/W installed.
>> There should be some limits based on PITCH settings and bandwith or not?
>> Tried to look in wiki and nothing about this there.
>>
>> http://www.zerobeat.net/mediawiki/index.php/Firmware_anomalies_that_are_considered_normal 
>>
>>
>> Maybe it is known, maybe not, maybe it is not normal, maybe yes...
>> Any comments?
>>
>> 73!
>> L. -dst-
>> K3/10 #272
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft   Help: 
>> http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>